Market construction
Market construction

Automatic car valve Iran Shir

Iran Shir
Iran

These valves are installed on the tank to allow gas to pass during refueling. These valves are also used to disconnect or connect the main path of the tank gas flow. These valves are designed to cut off the gas flow by closing them in times of danger or during repair.
You can also make a price as a seller
Request a price to negotiate and get a better offer

Suppliers

SuppliersExpiration datePrice (Toman)Minimum order (MOQ)CityPhone number
The price is not recorded

similar products

Automatic car valve Iran Shir

Main Task Reservoir Tasks

reservoir protection when the gas temperature rises sharply and the possibility of the tank explosion goes; In this case, the thermal fuse placed on the tank valve operates at 2 degrees Celsius and prevents the tank from explosion. In fact, this fuse opens the gas outlet to remove its excess pressure. Another task of this milk is to protect the tank against increased gas pressure. For these times, the fuse is mounted on the tank valve, which operates at the pressure of 2 atmospheres and prevents increased gas pressure inside the tank. This fuse removes the tank gas slowly and slowly when needed.

place a valve on the tank valves, which operates to protect and prevent interface or regulator tubes. The valve prevents excessive gas flow during the accident and limits the gas outlet from the tank. The tank valves are made in the type of thread used in both conical and cylindrical models. These valves are also divided into three categories:

  • Handheld tank tap
  • Electric tank valve
  • Handheld tank valve
  • Usually, to prevent leakage, place the tank valve and the pipe attached to it in a plastic or tire chamber, so that if leakage occurs, the gas is pushed out through the lower parts of the vehicle. Also, to connect the tank valve to its servant, you should refer to the conical or cylindrical model, the tank (rice or aluminum), how to close its torque and & hellip; >

    2-4 Electric valves (sulnoid)

    These valves have a fuel conversion key, which are responsible for choosing the type of fuel. When the gas fuel is selected, the gasoline valve cuts the gasoline flow and re -cut the gas whenever it is needed. On these valves, a 4V coil is mounted, which generates the force of magnetic attraction by passing the electric current. The same coil causes the springs to be compressed in the milk and the base of the valve moves and the fluid path return.

    Electric valves used in gas -fired devices are divided into two categories:

    • Gas Electric Valve
    • Gasoline Electric Valve

    1-2-6- Gas Electric Valve

    Electric valve installs gas in the gas inlet route to the regulator and is closed in the usual mode. The task of this valve is to close the gas inlet to the regulator. This valve can be placed in the high pressure area (on the tank valve and the regulator inlet) or the low pressure zone (regulator output). This electric valve is activated by the flow of the current. In this case, the gas path will open and the gas enters the regulator. Some electric valves makers put a paper filter inside the valves. This paper is similar to filter and clean the gas before entering the regulator.

    tips to consider when installing a gas valve:

    • This valve connection is prohibited in moving parts.
    • must be connected away from the heat source.
    • should be close to the regulator or tank valve.

    User's comments and scores