Destroyer of KATROCK Clinic Beton Iran

KATROCK destructor is a noiseless and safe destructive material that, unlike explosives, does not produce any noise, blast wave, earthquake, smoke and dust during destruction, and by creating a crack, it causes stone or concrete to corrode and separate. It is possible that this material does not require ammunition storage and special supervision for storage and use, and it can be used easily and without the need for experienced personnel in any place without risk.

Expenses

KATROCK for the destruction of concrete structures, rocks and large and hard stones in the following cases:

Destruction of structural parts that were wrongly concreted
Excavation and quarrying that was wrongly concreted
Digging a channel or well in rocky areas

special features

Simple and economical use
Noiseless and safe destruction
No stone throwing and blast wave

Physical and chemical characteristics
Physical state of the powder
Gray
Specific weight gr/cm3 6.1-7.1
pH 12-13

Consumption

The consumption of KATROCK depends on the distance between the holes and their diameter. The table below shows the approximate consumption of the destructor based on the diameter of the hole for holes with a depth of one meter.

Physical and chemical characteristics
Diameter mm 36 38 40 42 44 46 48 50
Amount consumed kg 1/7 1/9 2/1 3/2 2/5 2/8 3/2 3

How to use and essential tips

KATROCK in standing and free standing stones or concrete, the holes should be dug vertically, and in hidden stones and concrete, the holes should be dug at an angle of 30 degrees to the axis of the stone or concrete.

The distances of the holes should be regular and in accordance with the instructions. For this purpose, the distance of the first hole from the free edge of stone or concrete is maximum 15 cm and the distance of the holes in the middle starts from 25 cm. You can use the table below to determine the distance of the holes in the middle from each other. use

Physical and chemical characteristics
Hole diameter in mm 40 50 60
Degradable material type, distance between two holes mm
Reinforced concrete 30 50 60
Unreinforced concrete 40 70 100
Hard stones 30 40 60
Soft stones 40 80 120

The best diameter of the drill for digging holes is 40 or 50 mm
is.
For complete destruction, it is better to choose the depth of the pits between 80% and 90% of the height of the stone or concrete.
The inside of the pits must be completely clean and free of dirt and moisture.
KATROCK is packed in 25 kg bags and every 5 kg should be mixed with one and a third liters of water and in winter with 1.5 liters, the temperature of which is adjusted according to the ambient temperature.
In an environment with a temperature between 5 and 18 degrees Celsius, he used ordinary cold water to mix water between 25 and 35 degrees Celsius and at a temperature above 18 degrees.
Mixing should be done in a clean plastic bucket and continue until the resulting mixture is completely homogeneous and free of air bubbles.
It is mandatory to use safety glasses and rubber gloves for mixing.
After complete mixing, the mortar should be poured into the holes within 5 to 10 minutes.
The holes must be completely filled with mortar.
It is better to cover the filled holes with a wooden wedge or a piece of nylon to prevent direct sunlight and rain from falling into the holes.
Compliance with safety measures is mandatory in all stages.
The time of the destructive action depends entirely on the ambient temperature, and if the ambient temperature is higher, the reaction will be faster, and vice versa, in cold environments with low temperature, the action time will be higher.
It is necessary to choose the appropriate temperature for use with the ambient temperature.
Where you need to segment the stone and extract it from the mine, you can use a wooden wedge to create cracks in the desired direction.
Every season, KATROCK is suitable only for the weather of that season and can be used at that time. The water used for the mixture must be as clean as possible and at the right temperature. In cold weather, warm water between 25 and 30 degrees must be used to use the destructor. Consumed water must be free of any chemical waste so as not to reduce the destructive activity. In principle, it is better to use mechanical equipment for mixing, but it can be done with a hand mixer. The bucket used for mixing is better to be plastic. The water used must also be clean, and its temperature should be at 25 degrees Celsius. up to 30 degrees, the most suitable amount of water to add to 5 kg of summer destructor is one and a third and for winter material it is 1.5 liters. If the water used becomes less than the required expansion capacity, then it is necessary to pay attention to the percentage of water to mix the destructor. Because the destructor may lose its chemical power in the vicinity of air, it is better to open the door at the last stage and immediately mix the mixture with water and mix the resulting mortar until a completely homogeneous mixture is formed.
To mix the destructor at a temperature of 0 to 18 degrees, water between 25 and 30 degrees and at a temperature of 18 degrees and above, normal and cold water should be used.
The destructive paste should be poured into completely clean and moisture-free pits within 5 to 10 minutes. If there is water inside the pits, the paste should be poured into nylon bags or polyethylene tubes with low thickness and embedded in the pits. The appearance of the holes should be completely filled with destructive paste in order to have the most power for destruction. If the instructions are followed correctly, after 5 to 6 hours, depending on the degree of environment, you will have a safe destruction.
All the products that are produced and supplied by Iran Concrete Clinic (Mehrazan Paydar Consulting Engineers) are in accordance with international quality standards.

packing

KATROCK is supplied in 25 kg bags and its minimum storage time is six months.

inventory

KATROCK at

Store in a covered environment away from sunlight and rain and dry and cool temperature.

Quality assurance

All products produced and supplied by Iran Concrete Clinic Company (Mehrazan Peydar Consulting Engineers) are in accordance with international quality standards.
Are.

Buy and destroy the price of KATROCK

Making the market is a database and a network of manufacturers and suppliers of construction products that introduces companies and specialized reviews of construction products. The general purpose of building a market is to establish a direct relationship between the buyer and the producer. Dear buyers can refer to the market building system to find out about the KATROCK destroyer and buy from reliable sellers.

Manufacturers and suppliers can register in the market construction system and participate in the special sales festival by placing construction products and inserting the suggested price and increase the sale of their products.