SMD bubble lamp 10W Ecowat

SMD lens technology was removed from the part and the bases were suitable for surface installation. In this way, the size of the piece became very small. Also, due to the surface installation capability, the flexibility of the manufactured components increased. The heatsink with the cross section and the calculated blades in this lamp repels the proper heat from the diode to the outside air. Proper disposal of this heat increases the useful life of the lamp. Also, the driver components of the fixed current of the lamp and, most importantly, the inlet and outlet capacitors are cooled by the same aluminum part. If the capacitors in the power supply do not cool properly, the electrolyte inside them will evaporate and the lamp will start flashing. This problem is solved in eco-lamps and will not be a concern for the customer. In the case of motion sensors and eye sensors:Many customers ask about flashing low-power LED lamps in stairwell and parking sensors. There are two main reasons for these lamps to flash: the use of two-wire sensors and the direct connection of the phase wire to the inside of the coil. Dual-wire sensors are older generation currents that take their electronic board current from the lamp leakage current. This did not cause any problems for the old incandescent bulbs because it was very, very small compared to the mains bulb, but in LED and low-power bulbs this leakage current is stored in the capacitor and every few seconds with a light on and off cycle. Being emptied. The solution is to use three-wire sensors, which themselves separate the neutral wire sensor from the box, and the leakage current does not pass through the lamp. Also, the phase should not enter the lamp directly under any circumstances. This can lead to the risk of electric shock, except for the effect of flashing the lamp. In the case of headlightsThe switches that have the night light on also cause the lamp to flash due to the same leakage current. Do not use these types of switches next to LED lamps.